Sender Remote Set
Programming
The set of 3 wireless hand-held remotes have already been programmed to
button A.
In order to actuate the lock , press the A button of the remote. The red LED
will light and the door will begin its operation.
Programming new remotes
Press A+B button at the same time, you will hear a short beep. Then press
button A, you will then hear a continuous beep, and the remote will be in
teaching mode. Then press the buttons you wish to enable, you will hear
continuous short beeps.
If buttons are not pressed whilst programming within 5 secs, the programming
mode will cease.
Deleting remotes
Refer to the Operating Manual.
Replacing the batteries in your remotes
Refer to the Operating Manual.
Wireless receiver
3
Hand held transmitters (3),
Grey/light grey
2
1 Terminal block ( auxiliary
Interface) inc: 6 mtr long,
lock motor to terminal
block connecting cable
1
LED
Button A
Button B
2
1
3
Blue Top Locking System
