PROCEDURE
1
NOTE:
These procedures are applicable to a supply unit that has an independent
lubrication system.
Remove the covers (002,
Fig 10-27 Covers
2
There are two methods for this procedure:
•
Remove the fuel pumps, refer to
[section not applicable for this engine]
, or
•
Lift the rollers, refer to
3
Make sure that the bearing covers at positions No. 3 to No. 10 (
) and the
casing (00X), have marks to identify them as a set.
NOTE:
The bearing at position No. 2 has the two thrust bearing ring halves (002).
4
(003) to lift the rollers and guide pistons of the fuel pumps.
X82-B
AA00-5581-01AAA-523A-A
Maintenance Manual
Supply unit camshaft and bearing shell - prepare before removal
Winterthur Gas & Diesel Ltd.
- 601 -
Issue 001 2020-10
Summary of Contents for X82-B
