WZDS9100 #2
14
Line Voltage
1.
Run a 230-volt circuit from the service panel to terminals L1 and L2 on TB1 in the condenser control
panel. Check the Copeland rating plate or page 12 for the proper fuse size. Attach the ground wire to the
lug in the upper left hand corner of the condenser control panel.
2.
Load voltage for the ductless evaporator will come from terminals marked EVAP on TB1 in the condenser
control panel. Connect these wires to the small
terminal block
with the evaporator fan motor wires
attached. Attach the ground wire to the terminal with the green or green and yellow striped wire.
3.
Each unit must be installed in accordance with the National Electric code. Check local codes for additional
precautions and ordinances to installation.
