3. USING THE WINEMASTER C50 IN AIR-CONDITIONER
3.1 CONNECTING THE AIR-CONDITIONER
Connect the male plug to a 230V / 16A power socket. Switch on the air-conditioner by pressing
button 2
on the
diagram below. The fan on the cellar side comes on immediately. The compressor may not come on until 2
minutes later if the temperature in the cellar is higher than the set temperature. If the cellar temperature matches
the thermostat setting, the compressor will not come on.
If you want a setting temperature more quickly, you can press button 2 on position II. I this case, the speed of air
circulation increase and the wine cellar will reach nominal power.
For the cellars wich volume is higher than 20m3 (this volume could change according the insulation condition). It is
advisable, specialy during heat period, to always remain with position II.
3.2 CONTROL PANEL
The air-conditioner is equipped with an electronic thermostat fitted
to the front of the device so that the operating status of the
WINEMASTER
can be seen at any time from inside the cellar.
The thermostat permanently displays the temperature of the air in
the cellar which varies in range of 2 °C. The variation of the air
temperature carries a smaller variation than the wine’s one due to
the thermal inertia of the liquid.
The thermostat as been set by factory at 12°C. When you start the
cellar wine, you should verify and, if need, modify the temperature
following instructions below.
The IOII On/Off button
(ref. 2)
is used to switch the air-conditioner
on and off and to select the ventilation speed in the cellar.
The IO button
(ref. 3)
with a green light, indicates that the unit is on
and is used to switch on the integral lighting.
The diodes situated on the left side
(ref. 4)
from the thermostate are indicating that the air-conditioner is
defrosting, heating, or frosting.
The integral lighting permanently displays the temperature in the cellar and current functions. The diodes on the
left
(ref. 4)
of the thermostat show whether the air-conditioner is defrosting
, heating
, or cooling .
The thermostat is equipped with a joystick on the right
(ref. 1)
for changing settings or manual defrosting.
To change the setting, simply press the symbol
5
for 5 seconds. The display
(ref. 5)
then displays
SET
. Press
the symbol
5
again briefly. The set temperature is displayed.
To increase it, press the up arrow
. To reduce the setting press the down arrow
.
When the temperature setting is correct, press
5
until the display again displays
SET
.
After changing the setting, the compressor will only come on after a few minutes, because of a device which
prevents it from starting up too often.
W
INEMASTER
C50 IN
USER
GUIDE
03/2003
Page 30
3
2
1
5
4
II
I
I
0
12
O
5
Summary of Contents for C50 IN
Page 6: ...2 2 DIMENSIONS 2 3 INSTALLATION EXAMPLES WINEMASTER C50 IN USER GUIDE 03 2003 Page 28...
Page 14: ......
Page 15: ......
Page 16: ......