• Remove the bands that hold the door assembly to the pallet.
• Make sure that the door itself is secured in the closed position. This prevents that the
door moves during the lifting operation.
• Use at least two steadying lines to guide the door assembly during the lifting
operation.
4.3
Storage
4.3.1
Warehouse storage
• Store the parts in a safe, dry and dust free environment.
This prevents unnecessary damage and wear of the parts.
• If the parts were unpacked from their transport packing, repack the parts using
appropriate packing materials.
• Use the original WINEL BV pallet to store the door assembly.
• Do NOT stack pallets with the products on top of each other.
4.3.2
On-board storage
• Store the parts as close as possible to the future position.
• Make sure to place the door assembly at the correct side of the bulkhead.
• Make sure to protect the parts from damage caused by work in the vicinity of the parts.
• Re-pack or cover the door assembly and the other parts in order to prevent damage
by grinding or welding nearby.
4.4
Welding
4.4.1
General welding recommendations
Danger:
• Welding the door frame into or against the bulkhead must be done by a
certified and qualified welder and according to the requirements of the
shipyard and the applicable class society.
• WINEL BV cannot be held responsible if the welding recommendation and
the advised welding procedures were not followed.
WINEL BV can only make welding recommendations with respect to the product, not with
respect to the construction of the vessel to which the product is installed.
4.4.2
Welding instruction
Caution:
If you do not obey these instructions, you may cause damage to the product
and the watertightness of the product is not guaranteed.
Installation
19 - 001 - 29.05.2020
9
