Failure to install in accordance with product
manufacturer’s installation and assembly
instructions could result in property damage,
personal injury, and/or death.
Step 7
Rubber Feet,
Foot Screws
Rubber Feet,
Foot Screws
Assembling the Window Mount
To use with antenna models: PA-1000, PA1000R,
PA-2000, PA-2035, PA2000R, PA2035R, GM-
6000, GM-6035.
1. Align the hole in the clip with the press nut at
the top of the back support. The hole in the clip
should fit around the raised lip of the press nut.
Insert a 10-32 x 1/4
"
screw through the aligned
holes in the clip and back support, and tighten.
2. Push the two rubber bumpers through the two
holes in the bottom of the back support. Make
sure the rubber bumpers are fully installed before
proceeding, as these will prevent the mount from
scratching the vehicle.
3. Determine the preferred height of the window
mount base against the back support. Align the
bottom hole in the window mount base with the
preferred hole in the back support. Insert a
10-32 x 1/2
"
screw through the aligned holes
in the back support and base plate. Tighten.
4. Remove the two rubber feet and two foot screws
that will sit on the mount base from the bottom
of the antenna. Set aside until step 7.
5. Remove the dome screw facing the back support
with a 5/16
”
drive.
6. Align the hole in the dome with the hole in the
window mount base and back support. Install the
dome screw, with the rubber washer between the
dome and back support. Tighten.
7. To complete the installation, position the flat side
of the two rubber feet against the holes on the
bottom of the window mount base, and install
the two screws through the aligned holes in the
rubber feet, window mount base, and antenna
base. Tighten to 40 in* lbs.
Step 3
Step 1
Step 2
Step 4
Rubber
Washer
Back
Support
Dome
Screw
Dome
Step 7
Steps 5-6
