9
YES
On the connector on the
back of the control panel,
find the pins connected to
the
purple and black
(ground) wires. Measure the
DC voltage between these
pins. Does it measure 4.8-
5.0 VDC? Figure 19.
Have you tried
changing transpon-
ders? 11 for DISH, 1
or 3 for DIRECTV, 11
for ExpressVu.
Change transponders.
Measure screw heads con-
nected to
purple and black
wires on back of control
panel. Does it measure 4.8-
5.0 VDC? Figure 19.
For DISH, have
you cleared the
Check Switch,
started a new
search and run-
ning the Check
Switch again? For
DIRECTV, is the
receiver set to
“Two Sat. Oval
Dish”?
For DISH, retest
Check Switch
function; for
DIRECTV, set
receiver correctly.
Figure 18
Remove to
set switches
Is the primary (bright white) coax con-
nected to receiver that’s operating the
Check Switch routine? Fig. 21, 22.
NO
Operate Check Switch routine from
primary receiver.
YES
Are any devices inserted on the coax
between the satellite antenna and pri-
mary receiver?
YES
Remove device.
Fig. 21
Fig. 22
Fig. 20
t
Built-in stop (not visible)
119°
110°
t
t
Stop interrupts Check
Switch operation
Stop does not interrupt
Check Switch operation.
Built-in stop
(not visible)
119°
110°
t
Connects from electron-
ics box to PRIMARY
receiver.
NO
YES
Replace
electronics.
NO
YES
Are the rotary
switches set to the
proper satellite?
Figure 18.
Replace
connector.
Set to 119 for DISH
Network, 101 for
DIRECTV and 092
for ExpressVu.
Switches will ap-
pear upside down
and numbers coun-
terclockwise.
NO
NO
YES
NO
Figure 19
Screw head
connected to
purple wire
Screw head
connected
to black wire
Pin connected
to black
(ground) wire
Pin connected
to purple wire
Control panel inside RV
