Pro STAR Industries
1590-A N. Harvey Mitchell PKWY
Bryan, TX 44503
979-779-9399 1-800-262-7104
WAVE Instructions page 9
Trouble Shooting Chart
Condition
Corrective Action
No Power To Machine :
Dead electrical circuit breaker in fuse box
Check building circuit breaker.
Faulty power cord
Test power cord for continuity
I
Replace if necessary.
Power switch failure
Test switch for continuity. Replace if necessary
Faulty circuit breaker
Test circuit breakers for continuity/
Replace if necessary.
Intemal wiring problem
With the machine unplugged, check for, and correct, any loose wire
connections inside the machine at the switches and terminal block.
Electrical Shock:
Equipment not grounding
Follow grounding instructions exactly.
Receptacle not grounded
Have an electrician inspect the building’s wiring.
Internal electrical problem
Ensure that the machine’s wiring matches the appropriate wiring diagram.
Check for and correct any loose wire conneetions~ Replace any wires or
components which are short circuiting.
Vacuum Motor Soeed Varies or Doesn’t Run:
Circuit breaker tripped
Reset vac motor circuit breaker (13 amp).
Faulty vac circuit breaker
Check for continuity
I
Replace as necessary.
Intemal wiring problem
With the machine unplugged, check for, and correct, any loose wire
connections inside the machine at the switches and terminal block.
Power switch failure
Test switch for continuity
I
Replace if necessary.
Wom motor brushes
Replace if less than
1I4”.
Brush Motors do not run:
Circuit breaker tripped
Reset brush motor circuit breaker (2 amp).
Faulty brush circuit breaker
Check for continuity / Replace as necessary.
Internal wiring problem
With the machine unplugged, check for, and correct; any loose wire
connections inside the machine at the switches and terminal block.
Fautly brush switch
Remove leads and check switch for continuity. Replace.
Wom motor brushes
Replace if less than 3/8”.
Mechanical problems
Higher amp draws may indicate a mechanical problem. Find parts which are not moving freely
and repair or replace.
Faulty brush motor
If the belt, circuit breaker, and switch have been tested and found in good
working order, the brush motor may need to be replaced.
Loss Of Vacuum :
Bag full
Replace
Flapper in correct position
FLOOR TOOL
Damaged lid gasket
Replace
Accessory tool clogged
Clean out tool, ensure free airflow.
Vac hose damaged
Replace
Debris Chute Clogged
Remove chute access PN 05125 and clean chute out.
