Pro STAR Industries
1590-A N. Harvey Mitchell PKWY
Bryan, TX 44503
979-779-9399 1-800-262-7104
WAVE Instructions page 7
M
NOTE: THE FOLLOWING SERVICE ITEMS SHOULD BE PER-
FORMED BYAN AUTHORIZED SER VICE FACILITY ORAUTHORIZED
SERVICE PERSONNEL. ALL PARTS REFERRED TO IN THESE
INSTRUCTIONS CAN BE IDENTIFIED BY USING THE PARTS LISTS
AND ILLUSTRATIONS ON THE FOLLOWING PAGES.
WARNING
REMOVE MACHINE POWER CORD FROM ELECTRICAL
SOURCE BEFORE MAKING ANY REPAIRS OR ADJUSTMENTS
TO THE MACHINE.
TO ACCESS BELT/BRUSH MOTOR
1. Place machine in the upright storage position.
2. Remove (3) screws holding belt cover to chassis.
3.
Loosen brush motor and roll belt off brush pulley.
4. Remove (5) screws holding brush housing to
chassis - (3) Located on front of housing,
(2) Located on rear of housing.
5. Remove (2) screws from each end of brush housing and remove
brush assembly.
6.
Inspect/replace brush and bearings as required.
the brush is equipped with a yellow wear indicator bristIes. The brush
should be replaced when it wears down to the height of the yellow
bristles.
7. When installing belt push down on motor for proper tension.
8.
When reinstalling brush, check belt for proper tension.
TO ACCESS AND REMOVE VAC MOTOR
AND FILTERS.
1. Open lid cover.
2. Remove (2) screws from each/both vac motor brackets.
REMOVAL OF VAC MOTOR CARBON BRUSHES
1. Access vac motors as described above.
2. Vac motor can be lifted out and electrically disconnected.
—
WARNING
THE GREEN GROUND MUST ATTACH THE MOTOR TO THE
POWER CORD FOR SAFE OPERATION. SEE THE WIRING
DIAGRAM
.
NOTE:
WHEN REPLACING ELECTRICAL COMPONENT PARTS
REFER TO WIRING DIAGRAM FOR PROPER CONNECTION.
NOTE:
THE VAC MOTOR IS PROTECTED BY A CIRCUIT BREAKER
LOCATED IN THE SWITCH PANEL. THE BREAKER WILL ONLY
TRIP UNDER CONDITIONS OF ABUSE.
BRUSH MOTOR
1. Access belt and brush as described above.
2. Disconnect spring holding frame to brush motor housing.
3. Remove (4) bolts holding motor housing to the chassis and lift out
motor asm.
4. Remove brush motor pulley and (2) bolts holding motor to bracket
lift out brush motor.
CARBON BRUSH (PART NO. 140212)
1. Access belt and brush as described above.
2. Remove brush caps.
NOTE:
BRUSHES SHOULD BE
REPLACED WHEN WORN TO 3/8” OR LESS.
NOTE: BEFORE REINSTALLING BRUSH MOTOR BRACKET
ASSEMBLY IT’S RECOMMENDED THAT THE REAR
SPRING BE RECONNECTED TO THE FLAPPER
ASSEMBLY.
