ASSEMBLY INSTRUCTIONS
1.
Assemble the fan before plugging it in.
1.
Pass the power cord through the center notch of the rear
base.
2.
Connect the rear base to the front base by sliding it
downwards.
3.
Install the WindColumn into the base assembly, and
secure with the two supplied screws.
4.
Loosen the cord clamp under the base assembly. Place
the power cord under the cord clamp and secure it with
the clamp and screws.
IMPORTANT INFORMATION
THIS FAN IS NOT TO BE USED IN THE BATHROOM. Place
the fan on the ground close to an electrical outlet. Be sure the
location is level so that the fan is stable.
Place the fan out of the reach of children. Do not insert
anything into the grill. If moving the fan to a different location,
switch it off and unplug it from the socket.
CAUTION: The fan should not be used without
a base, nor used lying on its side.
3
REMOTE CONTROL PREPARATION
Remove the cover from the back of the remote control.
1.
Insert the two batteries (Two R03, AAA UM-4 dry cell
batteries).
2.
Do not use rechargeable batteries because they differ
from standard dry cell batteries in shape, dimension and
performance.
3.
Be sure to replace the batteries with two new batteries of
the same type.
4.
The LED on the remote control will illuminate when any
key is pressed.
5.
Remove the batteries if the fan is not going to be used
for an extended period of time.
6.
You can operate the fan by either the remote control or
the soft-touch buttons on the control panel.
A CHANGE IN THE FUNCTION IS USUALLY INDICATED
BY A BEEP.
4
