Page 3
60706-180
0310-00
B. The foundation must be solid enough to absorb generator
starting and reflected load torque during operation.
C. The foundation surface should be flat.
D. Space is required around the generator for mounting
switching devices, making connections, and for servicing.
E. The generator mounting bracket must rest evenly and
firmly on the foundation. Install shims if necessary to even
out the foundation under the mounting pads then bolt the
generator firmly in place.
TRAILER MOUNTING
Mount the generator on a trailer if you plan to use it as a
portable power source. When selecting or building a trailer to
mount the generator, consider the following points:
A. The trailer construction must be strong enough to support
the generator.
B. The design of the trailer must enable the trailer to remain
stable during operation, and to resist tipping caused by
generator starting and reflected load torque.
WARNING: Personal Injury & Equipment Damage
TRAILER MAY TIP OVER AND CAUSE INJURIES IF
WHEELS ARE NOT SPACED FAR ENOUGH APART.
Optional Trailer Part Number TDM75
C. The trailer height and mounting position of the generator on
the trailer should enable aligning the drive shaft (tumbling bar)
in a straight or nearly straight line between the power take-off
and generator input shafts. Misalignment must be less than 10
degrees during generator operation, even though the mechani-
cal design of the tumbling bar would allow greater misalign-
ment.
D. The generator mounting area of the trailer bed should be
flat.
All four generator mounting pads must rest firmly on the trailer
bed. Install shims if necessary to even out the bed under the
mounting pads, then bolt the generator firmly in place.
WINCO THREE POINT HITCH
Optional 3-Point Hitch Part Number TPH240
WARNING: Personal Injury & Equipment Damage
WHEN USING THE 3-POINT HITCH ASSEMBLY ALL THREE
POINTS MUST BE ATTACHED TO THE TRACTOR. FAIL-
URE TO DO SO WILL CAUSE THE GENERATOR TO TIP
WHEN LIFTING IT DAMAGING BOTH THE T-BAR AND THE
GENERATOR.
A. The three point hitch must be attached to the tractor at all
times during operation.
B. When operating the generator the three point hitch and
generator must be sitting on flat level ground. All four deck
pads must be in constant contact with the ground at all
times. This will reduce the vibration in both the generator
and the tumbling bar.
C. For safety the generator must be bolted to the three point
hitch deck using all four mounting bolts
