GENERAL MAINTENANCE
ADJUSTING GAS SPRING
NOTE: Tension or "ease of movement" of the gas spring is set by factory and cannot be
changed.
1.
Using 2 people (RECOMMENDED), tilt the chair over onto the Left side
and locate the Gas Spring
(FIG. 1)
. Loosen the 11/16" hex nut on the
Gas Spring located near the bottom-front of the chair.
(FIG.2)
2. On the opposite end of Gas Spring, remove the Bow-Tie
Cotter Pin and Clevis Pin - (save the 2 plastic Clevis Pin bushings)
(FIG.3)
Gas Spring can now be rotated for adjustment.
3. If Back of chair will not recline when "back release handles" are lifted
then you will need to Rotate the Gas Spring as shown, clockwise, one
half (1/2) of a revolution (or 180 degrees) - see
(FIG. 4A).
If Back of
chair reclines without lifting handles; then you will need to Rotate Gas
Spring as shown, counter-clockwise, one-half (1/2) of a revolution
(or 180 degrees).
(FIG. 4B)
4. Once you make an adjustment; Replace Clevis Pin, plastic bushings
and Bow-Tie Cotter Pin. Pull up on the Back Adjustment Handle to
check for proper adjustment. Repeat above steps as needed until
correct release action is achieved. Then TIGHTEN HEX NUT (that you
loosened in step 1) once the Gas Spring is adjusted properly.
8
FIG. 1
FIG. 2
FIG. 3
FIG. 4
~Make sure all bow tie cotter pins are securely inserted in all clevis pins
and that cable end is attached through slot of Operator.
~Failure to securely insert the bow tie cotter pins into the clevis pin
could cause the clevis pins to fall out and result in injury, or damage to
the chair.
GENERAL CARE & CLEANING
Remove hair & body oils; Your recliner should be cleaned with mild soap & water solution and a damp cloth on a regular
basis (especially where skin & hair make contact with upholstery). Avoid harsh detergents or chemicals that could
damage the upholstery or finish of your recliner. If the recliner is disenfected, the chair MUST be wiped off with ONLY
clean water on a damp cloth.
Note: Disinfectants alone, will not provide adequate "grease or oil cutting" properties to remove hair & skin oils. Over
time, the appearance and feel of your upholstery may diminish if not cleaned
properly.
Please refer to the
PERMABLOK
instruction tag that is attached to your Care Cliner for complete care and cleaning
instructions.
Retain information on tag for future use.
FOR FURTHER CLEANING INFORMATION VISIT:
http://www.wincomfg.com/permablok-info-and-cleaning-instructions
