OWNER’S MANUAL
PAGE 13
winchestersafes.com
PONY SERIES
ELECTRONIC LOCK OPERATING AND CHANGING
INSTRUCTIONS
(CONTINUED)
Keeping the door open, enter your new combination . If it was programmed correctly,
you will get two (2) beeps after entry and the handle will turn clockwise and retract the
locking bolts .
If at any time in the combination changing procedure you hear three (3) beeps, you must
start over at the beginning of Step 3 and repeat the entire procedure .
CHANGING YOUR PERSONAL COMBINATION IN THE FUTURE
You can reset your 6-digit combination at any time you choose . Please follow the
SETTING
YOUR PERSONAL COMBINATION
instructions on page 12 . You will have to use your personal
combination (rather than 1-2-3-4-5-6) as the existing combination . All other steps are the
same .
LOW BATTERY POWER
Repeated beeping after the entry of your 6-digit combination indicates that the
battery power is low . The safe may continue to open, but a new 9-volt ALKALINE battery
(ENERGIZER® or DURACELL® only) should be installed immediately . Refer to
INSTALLING
THE BATTERY
on page 11 for installation instructions .
BATTERY IS DEAD AND YOU CAN NOT OPEN THE SAFE
First of all, don’t worry . Your combination is retained in the lock even if all power is lost .
Simply install a new 9-volt ALKALINE battery to the connector (ENERGIZER® or DURACELL®
only) by referring to the
INSTALLING THE BATTERY
on page 11 for installation instructions .
Once battery is installed, the lock will open normally .
ELECTRONIC SAFE LOCKING INSTRUCTIONS
STEP 1-
Making sure there is not any obstruction inside the safe that will block the door
from closing or the movement of the locking bolts; close the door and rotate the handle
counterclockwise (turn right) until it comes to a solid stop .
STEP 2 -
Turn the dial counterclockwise (left) at least three revolutions . Your safe is now
locked .
