Wall fi tting
WimTec OCEAN W6
33
EN
OCEAN W6
Description of the functions
Enable the continuous fl ow function to fi ll the washbasin or a container.
“ON” position:
Continuous fl ow function is enabled.
“OFF” position:
Continuous fl ow function is disabled (preset).
Enable continuous fl ow if
cleaning stop function is
disabled (DIP 2 = OFF)
Position your hand (3 - 5 cm)
closely in front of the infrared
sensor (below the thermostat
handle) and wait. The illu-
minating icon starts fl ashing.
After fl ashing three times,
continuous fl ow is enabled
for the maximum fl ow time
confi gured.
During continuous fl ow, the
icon will glow continuously.
Activate continuous fl ow if
cleaning stop is activated
(DIP 3 = ON)
Position your hand closely in
front of the infrared sensor
(below the thermostat han-
dle) and wait.
The water begins to fl ow
and the illuminating icon
starts fl ashing. After fl ash-
ing 5 times, the cleaning
stop is previously active and
the water fl ow is stopped.
Continuous fl ow is activated
by waiting three further fl ash
impulses.
Deactivate continuous fl ow
Automatic:
After the fl ushing
stop time confi gured on the
time control has elapsed
(see p. 24).
Manual:
To immediately stop
the continuous fl ow, perform
the same steps used to en-
able the function.
3 x fl ashes
5 x + 3 x fl ashes
Continuous fl ow:
DIP switch 3
ON
OFF
2 3 4 5 6
1
10 s - 10 min
um 07:00 Uhr
Summary of Contents for OCEAN W6
