Press
VNA Menu
to go to the VNA Menu display
(below).
This menu lets you set the frequency offset and out-
put power level for the Slave 68XXXB in the VNA
mode.
Press
VNA Offset
to open the slave frequency off-
set parameter.
Press
VNA Level
to open the slave output power
level parameter.
Open the parameter you wish to change, then edit
the current value using the cursor control key or ro-
tary data knob or enter a new value using the key
pad and appropriate termination key. When you
have finished setting the open parameter, close it by
pressing its menu soft-key or by making another
menu selection.
Press
Previous Menu
to return to the Slave Fre-
quencies List menu.
Return to the Master-Slave menu and press
Enable
to begin master-slave operation.
SLAVE
During master-slave operations in
VNA mode, this error message is
displayed on the Master 68XXXB
when the slave offset value entered
results in a CW frequency or fre-
quency sweep outside the range of
the slave 68XXXB. Entering a valid
offset value clears the error.
USE WITH
MASTER-SLAVE
OTHER INSTRUMENTS
OPERATION
7-8
681XXB OM