Assembly and preparations
A. Main device and heating gun stand
№ Explanation
1
Remove the crew from the pole of the heat gun holder.
2
Place the pole in the bas.
3
Place the screw and secure the position of the pole.
4
Place the bracket and the stopper. Adjust the height an secure it with the screw.
B. Soldering iron
1. Follow the instructions for the “assembly of the soldering iron stand.”
2. Connect the electricity cable of the soldering iron with the soldering iron output connection at
the lower centre piece of the main unit.
3. Place the soldering iron in the soldering iron stand.
C. Pre-heater
Place the PCB fixture with safety screws in the required position.
Adjusting the multi-purpose PCB holder to the shape of the PCB.
D. Heat gun
To install the stand of the heating gun:
Use the 8 mm screw, to attach the holder to the station.
Place the heat gun on the holder in preparation for use.
© by WilTec Wildanger Technik GmbH
Item 90866
Page 6
http://www.WilTec.de
http://www.aoyue.eu
01 2021
-1