Adjusting the standby mode timer (heat gun)
Standardly the system has 30 min time before the heat gun goes into standby mode. This can be
altered the following way:
1. Whilst the heat gun is in the standby mode (showing “off” on the display,
1)
hold the “up” and
“down” button on the heat gun.
2. Wait until “t030” is shown on the display of the heat gun.
3. Let the buttons go as soon as “t030” appears.
4. Adjust the time with the “up” and “down” buttons of the temperature adjustment.
5. Confirm the changes by pressing the function switch of the heat gun.
6. The system immediately switches back into operation and uses the defined countdown para-
meters for the entire use.
Note:
The standby mode is adjustable between 1 and 30 min. The standby mode adjustment for the
heat gun and soldering iron are saved and stored until they are reset or new data is entered.
Automatic standby mode of the soldering iron
The standby mode of the soldering iron is standardly deactivated. Follow the following instructions to
activate this function:
Condition:
Function of the soldering iron is inactive.
Whilst the soldering iron is showing “off” or is in standby, push the “up” and “down” buttons of
the temperature adjustment of the soldering iron (
6
on the control panel).
Wait until “tOFF” is shown on the display of the soldering iron temperature adjustment. This
shows, that the standby mode is turned off at this point.
After the figures in the display change, let go of both buttons.
Use the same buttons to alter the timer. “t001” means that the soldering iron will go into
standby after one minute. The timer can be altered between 1 and 60 min.
Confirm the settings by activating the soldering iron button.
To deactivate this function, follow the steps mentioned above but select “tOFF” this time.
Whilst being in standby mode, the display will show “----” for the soldering iron temperature.
To stop the soldering iron from being in standby, push the button for the temperature adjust-
ment of the soldering iron.
Digital calibration
Digital calibration of the soldering iron
The system is standardly calibrated, but in case smaller alterations to the soldering iron need to be
carried out, the following steps can be taken:
1. Switch the function switch of the soldering iron on.
2. Adjust the required temperature, which you wish to calibrate. Place the tip of the soldering iron
on the external temperature sensor.
3. The display of the external temperature sensor should be more or less the same temperature
as the adjusted temperature.
4. If there are bigger deviations when measuring the temperature, the temperature settings can
be calibrated again.
5. Whilst the soldering iron is being used, make sure that the heat gun and the pre-heating func-
tion are switched off. (“OFF” is shown on the displays
1
and
2),
hold the pre-heater “up” button
for a few seconds until “0000” is shown on the display.
6. Adjust the temperature compensation via the “up” and “down” buttons on the soldering iron
settings.
© by WilTec Wildanger Technik GmbH
Item 90866
Page 10
http://www.WilTec.de
http://www.aoyue.eu
01 2021
-1