© by WilTec Wildanger Technik GmbH
Item 62593
–62594
Page 4
05 2021-1
Lifting load
Set the adjustment lever to
“UP” and turn the lever handle to the right to press the friction plates
(20)
and the ratchet disc
(13)
firmly against the brake seat
(33);
then the drive shaft
(11),
the disc
(2),
the
pinion shaft
(4)
and the gearwheel
(3)
can be driven. The load chain and lever handle are used to gently
lift the load (see Fig. 1).
Instructions for use
1. Do not overload the chain hoist.
2. Do not operate the chain hoist with a motor. It is only intended for manual operation.
3. All moving parts should be well lubricated at all times.
4. Before starting up, make sure that the various parts are not damaged and that the idle is in good
condition.
5. Immediately stop operating if you suddenly need to exert more force than normal on the lever
handle. Check the following:
•
Has something got stuck on the load?
•
Are there any problems with parts of the block?
•
Is the load heavier than the chain hoist can lift (nominal capacity)?
Technical specifications
Item number
62593
62594
62595
Max. capacity
(
㎏
)
750
1500
3000
Chain length
(m)
1.5
1.5
1.5
Load chain width
(
㎜
)
6
8
10
Drum (without lever)
(
㎜
)
130×120×110
170×150×140
220×180×150
Max. hook opening
(
㎜
)
20
25
30
Inner diameter hook
(
㎜
)
35
40
48
Weight
(
㎏
)
6.5
11
17
Important Note:
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.