Starting and turning off the device
The sprayer (1) and its jet pipe are under pressure during operation and have to be wielded with both
hands.
Important:
Direct the nozzle at the ground and check if the pressure washer is placed in an
upright position before starting the device.
Note:
Do not place the device in high grass!
1.
Unlock the lock of the trigger.
2.
Pull the trigger of the sprayer (1) and let water flow until the remaining air has escaped from
the hose.
3.
Use the power switch (7) and set it to the “I” position in order to start the device.
4.
Pull the trigger of the sprayer (1).
5.
Always adjust the distance and pressure to the surface that is supposed to be cleaned.
Note:
The pressure cleaner must not be covered during operation and must not be operated within a
room without sufficient ventilation. If the pressure washer is not in use for 5 or more minutes, the
device has to be turned off.
1.
Use the power switch (7) and set it to the “0” position in order to stop the device.
2.
Disconnect the device from the mains supply by carefully removing the power plug (12) from
the socket-outlet.
3.
Close the water supply and pull the sprayer trigger (1) in order to release the pressure from
the device.
4.
Use the trigger lock in order to lock the sprayer and prevent an unintentional activation.
Note:
If the trigger is not being pulled, the device will automatically stop its operation and will restart as
soon as the trigger is being pulled again.
Multiple nozzle
The pressure of the water released by the nozzle can be adjusted.
Warning:
Never try to adjust the
pressure while the device is operating in order to prevent severe injuries from your hand being hit by
the high-pressure water jet.
© by WilTec Wildanger Technik GmbH
Item 62571
Page 8
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1