Throttle wire
After fitting up the wire make sure that the throttle
cable is put in the throttle lever. If not it is very dan-
gerous because the engines rotate after releasing
the throttle.
1. Hook the cable end into the hole of the throttle
lever. And set the cable in the lever as shown in the
picture.(F4)
2. Wrap the band so as the throttle wire is fixed with
the handle.
(1) Hole
(2) Throttle cable
Adjusting the throttle cable
1. after releasing the throttle lever pull the throt-
tle wire. The normal play is 1 or 2 mm when
measured at the carburetor side end.
2. If the play is short or long take off the air
cleaner cover loosen the lock nut and adjust the
play.(F5)
(1) Adjust nut
(2) Lock nut
Installing the metal blade (F6)
1. Set the inner holder to the gear shaft and fix
with the attached L-shaped bar.
2. Put the blade on the inner holder with letters to
the gear case and match correctly the hole of the
blade
to the projection of the inner holder.
3. Set the outer holder to the gear shaft with the
hollowed face to the blade.
4. Put the attached bolt cover on the outer holder
and secure it with the bolt (left screw) together
with the spring washer and the washer.
(1) Nut
(2) Spring Washer
(3) washer
(4) Outer holder
(5) Blade
(6) Gear shaft
(7) Bar
(8) Inner holder
(9) Gear case
© by WilTec Wildanger Technik GmbH
Seite 29
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
