background image

AMPLIFIER CANADIAN SPECIFICATIONS

Dual Band

800/1900 MHz Specifications

Impedance (input/output)

50 ohms

Frequency

824-894 MHz / 1850-1990 MHz

1

Passband Gain (nominal)

800 MHz uplink

40 dB (typical) / 46 dB (maximum)

800 MHz downlink

40 dB (typical) / 49 dB (maximum)

1900 MHz uplink

41 dB (typical) / 50 dB (maximum)

1900 MHz downlink 

41 dB (typical) / 50 dB (maximum)

2

20 dB Bandwidth (nominal)

800 MHz (uplink/downlink)

35 MHz / 45 MHz (maximum)

1900 MHz (uplink/downlink)

70 MHz / 87 MHz (maximum)

Power output for single cell phone (uplink)

800 MHz

1900 MHz

CDMA

31.4 dBm

30.1 dBm

GSM

26.9 dBm

26.3 dBm

EDGE

26.0 dBm

25.1 dBm

Power output for single received channel (downlink)

800 MHz

1900 MHz

CDMA

5.6 dBm

1.8 dBm

GSM

0.7 dBm

-2.7 dBm

EDGE

-2.5 dBm

-6.4 dBm

4

Power output for multiple received 

channels (downlink). 

 The maximum power 

is reduced by the number of channels:

Number of channels

Maximum Power

3

800 MHz

1900 MHz

2

6.7 dBm

0.2 dBm

3

3.2 dBm

-3.4 dBm

4

0.7 dBm

-5.9 dBm

5

-1.3 dBm

-7.8 dBm

Power Requirements

12 V DC (Nominal), 1.2 A

NOTES

1. Nominal gain is the maximum gain at any frequency in the passband.

2. Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB lower than the passband 

amplification.  One of the frequencies is lower than the passband and the other is higher.

3. The Manufacturer’s rated output power of this equipment is for single carrier operation.  For situations when multiple carrier signals are present, the rating would 

have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users.  This power reduction is to 

be by means of input power or gain reduction and not by an attenuator at the output of the device.

4. Data is in accordance with IC spec RSS-131.  The maximum power for 2 or more simultaneous signals will be reduced by 6 dB for each doubling of the number 

of signals.

Wilson

®

 Electronics, Inc.

 

 

 

 

 

 

 

 

Phone: 8

77-594-5766

 

 

 

 

 

 

 

 

 

Fax: 

866-827-4052

 

 

 

 

 

 

 

 

www.

wpsantennas

.com

 

 

 

 

 

 

              Part #110777 - C-Booster™ 010 / 06.09.09

30-Day Money-Back Guarantee

All Wilson Electronics products are protected by Wilson’s 30-day money-back guarantee.  If, for any reason, the performance of any product is not acceptable, simply return 

the product directly to the reseller with a dated proof of purchase.

1-Year Warranty

Wilson Electronics amplifiers are warranted for one (1) year against defects in workmanship and / or materials.  Warranty issues may be resolved by returning the 

product directly to the reseller with a dated proof of purchase.  

Amplifiers may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) 

number supplied by Wilson Electronics.  Wilson shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced 

product back to the original consumer within the continental United States.  

This warranty does not apply to any amplifiers determined by Wilson Electronics to have been subjected to misuse, abuse, neglect, or mishandling that alters or 

damages physical or electronic properties.  
RMA numbers may be obtained by phoning Technical Support at 

877-594-5766

  

Operation  is  subject  to  the  following  two  conditions:  (1) This  device  may  not  cause  interference,  and  (2)  this  device  must  accept  any  interference,  including 

interference that may cause undesired operation of this device.

Disclaimer:   The information provided by Wilson Electronics, Inc. is believed to be complete and accurate.  However, no responsibility is assumed by Wilson 

Electronics, Inc. for any business or personal losses arising from its use, or for any infringements of patents or other rights of third parties that may result from its 

use.
Copyright © 2008 Wilson Electronics, Inc.  All rights reserved.

wpsantennas.com

1-877-594-5766

wpsantennas.com

1-877-594-5766

Summary of Contents for SIGNALBOOST C-Booster









Reviews: