Wilson Electronics Grand Slamm, Owner'S Manual, Page: 45 / 80

W I L S O N A U D I O S P E C I A L T I E S , I N C .
4-7
X-1/ G
RAND
SLAMM O
WNER
’
S
M
ANUAL S
E C T I O N
4 . 1 M
O U N T I N G
U
P P E R
A
R R A Y
M
O D U L E S
C
ONNECTING THE
U
PPER
R
ANGE
S
IGNAL
C
ABLE
The X-1/Grand SLAMMs use binding posts that were design in house and are manufactured exclu-
sivly for Wilson Audio, they are superior to most common connectors. A note about these connectors: These
connectors should be tighted to snug, if they are over tightened they will break. Once they are secure, they
will remain that way.
The upper range signal cable is connected to the connector plate at the rear of the X-1 base. This is
accomplished as follows:
• Carefully remove the protective sleeve from the end of the cable
• Connect the cable to the “array out” terminals on the connector plate (see Figure 19).
U
PPER
R
ANGE
S
IGNAL
C
ABLE
A
MPLIFIER
I
NPUT
C
ONNECTION
F
IGURE
19 M
AIN
C
ONNECTOR
P
LATE