7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Outside Antenna Installation
The antenna should be mounted as shown in the illustration on page 5. The
mounting bracket, included with antenna, is adjustable and will accommodate
pipe diameters from 1.25” to 2” (pipe sold separately #901117). Mount the
antenna so that there is at least 3 feet of clearance in all directions around
it. Position the antenna so that it has an unobstructed line of sight to the cell
tower’s strongest signal. Make sure the antenna is not pointing across your own
roof or at the Inside Antenna as this will cause the oscillation protection circuitry
to shut down the Signal Booster.
Warning:
The Outside fixed Antenna must be connected with a minimum of
26 feet of RG58 coax cable.
Warning:
Lightning protection is recommended for all installations
(#859902-50 Ohm shown below). Take extreme care to ensure
that neither you nor the antenna comes near any electric power
lines.
Installing Lightning Protection
(sold separately)
Install the Lightning Surge Protector
(LSP) close to the Signal Booster. Attach
the cable from the Outside Antenna to
the surge protector, using a short length
of low loss cable; attach one end to the
LSP and the other to the Outside Antenna
connector on the Signal Booster. Ensure
the LSP is properly grounded (ground
wire not included). LSP sold separately,
go to
www.WilsonElectronics.com
or call
800-204-4104 to order.
(not included)
Lightning
Surge Protector
(sold separately)
Signal Booster
Surge Protector Power Strip
Ground Wire
(not included)
To Outside
Antenna
To Signal
Booster
To Inside
Antenna