2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Select a location to install the Signal Booster that is away from excessive heat,
1.
direct sunlight, moisture and has proper ventilation. Do not place the Signal
Booster in an air-tight enclosure.
Select a location on the roof of the building to install the Outside Antenna. Use a cell
2.
phone in test mode to find the strongest signal from the cell tower. Refer to page 7.
Visit
www.WilsonElectronics.com
to find the test mode function for your particular cell
phone.
Run the Outside Antenna cable to the Signal Booster and attach it to the connector
3.
labeled “Outside Antenna” on the Signal Booster. Refer to page 8 for more
information on running cable. Lightning Surge Protection is recommended for all in-
building installations refer to page 6.
Select a location for the Inside Antenna, preferably in the center of where the
4.
signal needs to be amplified. A minimum separation distance of
20
vertical feet
(within the null zone) or 50 horizontal
feet
is necessary for proper operation.
If the inside coverage is not sufficient you may need as much as
75 feet of
horizontal
separation (refer to installation diagram on pages 3 & 4). Run the
Inside Antenna cable to the Signal Booster and attach it to the connector labeled
“Inside Antenna” on the Signal Booster.
Before powering up the Signal Booster, verify that both the Outside Antenna and
5.
the Inside Antenna are connected and check that all connections are tight. Refer
to page 9.
Note:
Be careful when plugging the connectors in so as not to bend
the center pins on the connectors.
If the light is not green, please refer to pages 10 & 12.
6.
Quick Install Overview
See Installation Diagram on page 3 & 4. Contact Wilson Electronics
Technical Support Team with any questions at 866-294-1660.
Warning:
Connecting the Signal Booster directly to a cell phone with use of
an adapter will damage the cell phone and/or the Signal Booster.
IMPORTANT NOTICE
It is very important to power your Signal Booster using a
•
surge protected AC Power Strip with at least a
1000 Joule
rating.
Failure to do this will void your warranty in the
•
event of a
power surge or lightning strike.
