7
8
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Hours: 7 am to 6 pm MST.
Splitter Options:
3-way
(859980)
4-way
(859981)
2-way
(859957)
(sold separately)
Installing the Inside Antenna
(Instructions are for optional Panel Antenna)
Select a location for the Inside Antenna, preferably in the center of where
the signal needs to be amplified . A minimum separation distance of 20
vertical
feet is necessary for operation . If the inside coverage is not
sufficient you may need as much as 75 feet of
horizontal
separation . See
installation diagram on pages 3 & 4 .
Ceiling
Rafters
Ceiling
Drywall
Inside
Antenna
After drilling the required hole, run the cable through and seal it with cable
bushings, silicone or other waterproof sealant to enclose the hole that you
have created . In some instances, it may be possible to run the cable up
into the fascia of the attic overhang . In this circumstance, the cable will be
accessible in the attic for further routing .
In some cases, multiple Inside Antennas may be required, for instance if
you have multiple rooms with poor signal . A signal may be split by using
a splitter (sold separately) . If using more than one Inside Antenna, a
separation up to 75
horizontal
feet may be necessary between Inside
Antennas . See configuration on pages 3 & 4 .
Warning:
An Inside Antenna must have a separation distance from all
persons that is at least 15 inches for the Panel Antenna .
Optional Wide Band
Inside Antenna
(sold separately–
multiple mounting
options
)
