1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Hours: 7 am to 6 pm MST.
Quick Install Overview
See Installation Diagram on page 3 . Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660 .
Select a location to install the Signal Booster that is away from excessive
1 .
heat, direct sunlight, moisture and has proper ventilation . Do not place the
Signal Booster in an air-tight enclosure .
Select a location on the roof of the building to install the Outside Antenna .
2 .
Use a cell phone in test mode to find the strongest signal from the cell
tower (see page 6) . Visit
www.WilsonElectronics.com
to find test mode
function for your particular cell phone .
Run the Outside Antenna cable to the Signal Booster and attach it to
3 .
the connector labeled “Outside Antenna” on the Signal Booster . Run the
Inside Antenna cable to the Signal Booster and attach it to the connector
labeled “Inside Antenna” on the Signal Booster . For more information on
running cable (see page 7) . Lightning Surge Protection is recommended
for all in-building installations (see page 6) .
Select a location for the Inside Antenna, preferably in the center of
4 .
where the signal needs to be amplified . A minimum separation distance
of
20
vertical (within the null zone) or 50 horizontal
feet is necessary
for proper operation . If the inside coverage is not sufficient you may
need to increase the separation distance even further (see installation
diagram on pages 3 & 4) .
Before powering up the Signal Booster, verify that both the Outside
5 .
Antenna and the Inside Antenna are connected and check that all
connections are tight .
Note:
Be careful when plugging the connectors
in so as not to bend the center pins on the connectors
(see page 9) .
The Signal Booster has been packaged with the gain control knobs
6 .
adjusted to the highest gain position . If any of the lights are not green,
please refer to pages 10-12 .
Warning:
Connecting the Signal Booster directly to a cell phone with
use of an adapter will damage the cell phone and/or the
Signal Booster .
IMPORTANT NOTICE
It is very important to power your Signal Booster using a
•
surge protected AC Power Strip with at least a
1000 Joule
rating.
Failure to do this will void your warranty in the
•
event of a
power surge or lightning strike .
