WILSON AUDIO WATT System 8, Owner'S Manual

Page: 32 / 74

the WATT to the Puppy and are used to correct propagation delay. “A” spikes are always
installed in the front two positions (the threaded holes located near the bottom front of
the enclosure). These two spikes screw into the WATT as shown in Figure 3. The spikes
should be screwed in all the way, until they are hand tight. Do not over tighten spikes.
Mounting the WATT on the Puppy
• Place the Puppy enclosures into the selected room location (as determined
by Section 1).
• Measure the listening distance and ear height (see example on Puppy top).
• Using the Propagation Delay Correction Table, select the required Align-
ment Spike.
• Install the Align-
ment Spike until
snug.
• Carefully, place
the WATT’s two
front spikes into
the rear of the
Puppy guide
track (see Fig-
ure 4). Hold
the back of the
WATT above the
Puppy surface
such that the
rear spike does
not damage the
top of the Pup-
py. Carefully
W A T T / P
u P P y
S
y S T e m
8 O
W n e r
’
S
m
A n u A l
W i l s o n A u d i o S p e c i a l t i e s
f
igure
4 - t
oP of the
P
uPPY
,
With SPike guiDeS AnD reAr SPike
recePtAcle
�
WATT S
pike
p
lAcemenT
G
uide
p
hASe
d
elAy
c
orrecTion
T
Able
p
AinTed
i
nner
e
dGe of
p
uppy