WILSON AUDIO Activ XO, Installation And Care Manual

Page: 28 / 44

28
ActivXo I n stal l ation and Car e G u ide
A u t h e n t i c E x c e l l e n c e ™
Section 3.1 - Twelve-volt Trigger Controls
Certain features of the ActivXo are controllable via a series of twelve-volt
triggers. The triggers allow remote control access of these features by external
control systems, Audio/Video, etc. This is a feature provides more convenient
and seamless operation of the ActivXo within home theaters and complex audio
systems.
Connect the 12-volt triggers via standard DC ports located adjacent to the
audio inputs on the rear of the ActivXo. You can switch the following functions
via the triggers: On/Off (Stand By); Line/Processor; High Pass Filter In/Out; Low
Pass Filter In/Out.
To access control of one of these four features via its twelve-volt trigger,
move the switch corresponding to that function to the “Rem” position. The
switches for Line/Processor, High Pass Filter In/Out, and Low Pass Filter In/Out
are three position toggles located on the front control panel. If you wish to
control any of these features via the twelve-volt trigger, move the correspond-
ing switch to the center position labeled “Rem.” The switch for the Stand By
On/Off control is located on the right-hand side of the front panel. Leave this
switch undepressed when controlling this function via the twelve-volt trigger.
Please Note: Only the switches relevant to the features to be remote con-
trolled should be switched to the “Rem” position. Toggling the switch to
the remote position without a twelve-volt trigger connected to that switch
will potentially result in your ActivXo being improperly configured. The
A u t h e n t i c E x c e l l e n c e ™