Wilo Helix VE 11kW-IE5, Installation And Operating Instructions Manual

Page: 36 / 48

English
36
WILO SE 10/2022
Access lock
The “Access lock” can be used to block all
adjustments to the pump.
Proceed as follows :
• Place DIP switch 2 in the ON position.
The menu <7.0.0.0> will appear.
• Turn the rotary knob to activate or deactivate
the lock. The current status of the lock is
represented by the following symbols
:
Lock activated : The parameters are
locked and access to the menus is
authorised in read-only mode.
Lock deactivated : The parameters can
be changed and access to the menus
to make adjustments is authorised.
• Place DIP switch 2 in the OFF position. The status
setting will reappear.
9. Maintenance
All servicing must be performed by an autho-
rized service representative only!
WARNING! Risk of electrical shock!
Ensure that any electrical hazard is avoided.
Ensure that the power supply is switched off and
secured against unauthorised switching before
performing any work on the electric system.
WARNING! Risk of scalding!
In case of high water temperatures and high system
pressures, close the insulating valves upstream and
downstream of the pump.
First, allow pump to cool down.
- These pumps are maintenance free. Nevertheless
a regular check is recommended every
15 000 hours.
- Optionally, the mechanical seal for certain mod-
els can be replaced easily thanks to its cartridge
design.
- In case of pump with half flanges design and
installation again after maintenance operation,
it is suggested to add plastic link to maintain in
easy way the half flanges together.
- For pumps equipped with one grease feeder
(Fig. 7, pos. 1), respect lubrication frequences
mentioned on sticker glued on lantern part (2).
- Insert its adjusting wedge in its housing (Fig. 6)
once mechanical seal position is set.
- Always keep the pump perfectly clean.
- Pumps which are not being used during periods
of frost should be drained to avoid damage:
Close the guard valves, open completely the
drain-priming plug and the air bleed screw.
- Service life: 10 years depending on the oper -
ating conditions and whether all requirements
described in the operation manual have been
met.