26
LimbLogic Battery Charger
This product is designed to work with WillowWood
products specifically designed for its use. Use Willow-
Wood charger part number LLV-21011. Use with other
products may result in harm to the device, the user, or
both, may void the warranty, and may negatively affect
EMC performance and/or compliance. Refer to product
manuals to verify compatibility with this charger before
attempting to use this charger with the product.
Electrical Ratings:
Rated input: 100 – 240 Vac, 0.6 A, 47 – 63 Hz
Rated output: 13.8 Vdc, 2.6 A
This product complies with: EN 60601-1-2:2007, IEC
60601-1-11:2010, IEC 60601-1-6:2010, IEC 60601-1-2 ED.
3.0, and IEC 60601-1:2005 +CORR.1(2006) + CORR. 2
(2007) and meets the “ICNIRP GUIDELINES FOR
LIMITING EXPOSURE TO TIME-VARYING ELECTRIC
AND MAGNETIC FIELDS (1 HZ – 100 kHZ):2010”.
FCC AND IC COMPLIANCE INFORMATION
FOR THE SIDE MOUNT PUMP
This equipment contains:
FCC ID U3V-LLV21011
and module FCC ID XDULE40-S2
Module IC: 8456A-LE4S2
Cet équipement contient:
Module d’émission IC: 8456A-LE4S2
FOR THE DISTAL MOUNT PUMP
This equipment contains:
FCC ID U3V-LLV21011
and module FCC ID XDULE40-S2
Module IC: 8456A-LE4S2
Cet équipement contient:
Module d’émission IC: 8456A-LE4S2
FOR THE FOB
Module FCC ID XDULE40-S2
Module IC: 8456A-LE4S2
Cet équipement contient :
Module d’émission IC: 8456A-LE4S2
FOR THE CHARGER
This equipment contains:
FCC ID U3V-LLV21011
IC:
7475A-21011
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1.
This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Radio Frequency Interference Statement
This is a Class B product. In a domestic environment, this prod-
uct may cause radio interference in which case the user may be
required to take adequate measures.
Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Technical Information