Installation
8
Optional Air Inlet Kit (Figure 7-9)
If using the optional air inlet kit 9310, install the O-Ring gasket
provided in the kit shown in figure 8. Figure 7 shows the standard
Inlet pipe stop bracket; this will prevent the PVC pipe from being
pushed too far into the back of the furnace. See Venting section.
After cutting the vent and gas openings, place the rear panel
back onto the wall and screw into place using the supplied
mounting screws. The screws should go into the wall studs as
there are enough clearance holes on the rear panel to allow this.
Use both top and bottom row of screw holes to attach. Remove
the front panel and push the heater onto the wall at a slight angle
and place onto the hooks on the rear panel to hold the heater
permanently in place. Install the front panel back on.
FIGURE 5
FIGURE 6
FIGURE 7
