Installation
The furnace operates in the following sequence:
1. The control turns on the main burner.
2. Heat builds up in the furnace and starts the fan. The heated
air comes out the panel louvers.
3. When the thermostat setting is reached, it shuts off the
main burner.
4. The fan runs until the heat is removed from the furnace,
then it turns off.
Your furnace is equipped with a built-in pressure regulator. L.P.
gas models also have a regulator at the supply tank. If you
have a question regarding the amount of fuel consumed, call
your local gas utility or gas supplier.
WARNING:
DO NOT TAMPER WITH THE
REGULATOR OR BURNER ORIFICES, AS
PROBLEMS RESULTING FROM THERE MAY
CAUSE PRODUCT FAILURE NOT COVERED
BY WARRANTY.
Input and output ratings shown on the rating plate, located in
burner compartment, must not be exceeded.
IMPORTANT:
KEEP
BURNER
AND
CONTROL
COMPARTMENT CLEAN BY CLEANING REMOVABALE
FILTER PERIODICALLY.
WARNING:
Do not store or use gasoline or other
flammable liquids or vapors near the furnace.
WARNING:
Danger of bodily injury or death. Do
not operate the furnace with a broken or missing
pilot observation door.
FIGURE 30
