Williams Sound WIR RX4 Instructions Download Page 3

S

TEP

5: I

NSTALL THE

R

ECEIVER

B

ATTERIES

Load two AAA batteries into the RX4 Receiver.
Be careful not to bend the plastic tabs when you
replace the battery door.

Be sure to insert the battery “plus” and “minus”
terminals correctly. DO NOT force them in back-
wards.

S

TEP

6: U

SING THE

R

ECEIVER

Make sure your TV or Audio Source is turned ON.
Turn the receiver’s Power Switch to ON. Place the
headset on your head and locate the Volume
Control Wheel. (See Figure 3.) 

The headband size can be adjusted by pulling or
pushing on each earpiece. Adjust the headset vol-
ume to a comfortable level. 

The infrared receiver “eye” is located on top of
the headset. Do not cover it up or you will lose
reception.

Be sure to turn the Receiver OFF when it is not
in use.

I

N

C

ASE OF

D

IFFICULTY

If the system does not seem to be functioning:

1. Make sure that your television is plugged in

and turned on.

2. Make sure that the TX295 Transmitter is

plugged in and correctly connected to the TV
or VCR’s audio output. 

3. Make sure the TX295 is operating on 95 kHz, 

not

stereo or 250 kHz mode.  See Step 3.

4. If you’re using the TV Mic and not getting a sig-

nal:  1) Be sure the audio cable is not plugged
into the TX295;  2)  Try turning the TV volume
up slightly;  3) Try positioning the TV mic
directly over the TV speaker.

5. Make sure that the RX4 Receiver has working

batteries.

6. Make sure you are not covering the RX4’s

infrared “eye.”  Remove any objects obstruct-
ing the line between the TX295 Transmitter
and the RX4 Receiver.

7. If you’ve installed the TX295  Transmitter

other than on top of the TV, make sure that its
front panel is facing the RX4 Receiver.

8. If the system still does not function, call

Williams Sound Product Service at
1-800-843-3544.

W

ARRANTY

The WIR 175 Listening System carries a five year
parts and labor warranty on the TX295  Transmitter
and RX4 Receiver. The TV microphone, earphones,
headphones, rechargeable batteries, adaptors, and AC
to DC Power Adaptor carry a 90 day warranty. Be
sure to fill out and mail the Warranty Card to register
your serial number and warranty.

On/Off
Switch

Volume
Control

Battery
Door

Williams Sound 

®

Helping People Hear

3

F

IGURE

3: RX4 R

ECEIVER

Summary of Contents for WIR RX4

Page 1: ...able with dual RCA plugs WCA 078 BAT 010 Power Supply STEP 1 SET UP THE TX295 TRANSMITTER The WIR TX295 Transmitter may be placed on top of a TV or shelf Place the TX295 Transmitter where it is clearly visible from your listening position Infrared light behaves like visible light so it is blocked by solid objects This confines the signal to the room where the transmitter is located The transmitter...

Page 2: ...ransmitter is now setup to operate with the RX4 receiver STEP 4 CONNECT THE TRANSMITTER TO THE AUDIO SOURCE If you are using the TV Microphone plug it into the Mic jack on the TX295 as shown Use the Velcro strip supplied to attach the microphone near the loudspeaker of your TV The micro phone will allow you to play the TV at lower volume for other listeners and will pick up other important sounds ...

Page 3: ...tput 3 Make sure the TX295 is operating on 95 kHz not stereo or 250 kHz mode See Step 3 4 If you re using the TV Mic and not getting a sig nal 1 Be sure the audio cable is not plugged into the TX295 2 Try turning the TV volume up slightly 3 Try positioning the TV mic directly over the TV speaker 5 Make sure that the RX4 Receiver has working batteries 6 Make sure you are not covering the RX4 s infr...

Page 4: ...ontrol 35 dB compression range Infrared LEDs Pattern 8 IR LEDs 45 degree cone shaped coverage pattern to 6dB intensity 30ft 9m line of sight Charging Ports Charges one WIR RX295 Receiver not included Warranty 5 years RX4 Receiver Weight 5 4 oz 154 g with batteries Earpad Size 6 5 cm 2 5 Diameter adjustable headband uses HED 023 foam cushions Material and Color ABS plastic Textured Gray Battery Typ...

Reviews: