Ideally, the TX295 Transmitter should be at ear-level height or above. The infrared light pat-
tern is much like a floodlight “cone” as it leaves the transmitter, with the best reception inside
the cone.
Sunlight can cause infrared interference in the form of a buzz, hiss, or static. Thus, the system
cannot be used outdoors and may not work properly inside if a lot of direct sunlight is present.
Closing drapes or blinds will help if sunlight is a problem.
Any number of receivers may be used with the TX295 Transmitter, but use only one transmit-
ter in a room at the same time. Otherwise, interference will occur.
S
TEP
2: C
ONNECT THE
T
RANSMITTER
P
OWER
S
UPPLY
Plug the Power Supply cord into the “DC 12V” jack on the back of the TX295. Then plug the
Power Supply into an AC outlet.
S
TEP
3: S
ELECT AN
O
PERATING
F
REQUNCY FOR THE
TX295 T
RANSMITTER
To use the TX295 transmitter with the RX4 receiver, you must first setup the transmitter to oper-
ate in 95 kHz mode. Referring to the diagram above, slide the Stereo/Mono Selection Switch to
the “L” Left position for 95 kHz. The transmitter is now setup to operate with the RX4 receiver.
S
TEP
4: C
ONNECT THE
T
RANSMITTER TO THE
A
UDIO
S
OURCE
If you are using the TV Microphone, plug it into the “Mic” jack on the TX295 as shown. Use
the Velcro strip supplied to attach the microphone near the loudspeaker of your TV. The micro-
phone will allow you to play the TV at lower volume for other listeners and will pick up other
important sounds like the telephone or doorbell ringing.
To use the supplied Audio Cable to connect the TX295 Transmitter directly to TV, VCR, or
other equipment output jacks:
Connect the LEFT RCA plug from the TV (or VCR) speaker output into the LEFT RCA
jack on the TX295 transmitter. Remember, the Stereo/Mono Selection Switch must be in
the “L” Left position to transmit in 95 kHz!
When the Audio Inputs are used, the Mic input is automatically disabled.
NOTE: The TX295 has an automatic shut-off feature that turns the Transmitter off 90 seconds
after the audio signal is no longer present.
Williams Sound
®
Helping People Hear
2
S
ETTING UP THE
TX295 T
RANSMITTER
Power
Input
ST =
Stereo mode
L =
95 kHz mode
R =
250 kHz mode
Stereo/Mono
Switch
RCA Jack
(connect from TV speaker output).
STEREO:
Use both RIGHT and LEFT jack.
95 kHz or 250 kHz:
Use LEFT jack only.
Mic
Jack
R
+
-
DC12V
L
MIC
ST
L
R
