5
EN
Parts
Assembly
1. Insert both legs into the brackets so you get a stable foot.
2. Remove the pre-mounted screws from the bottom of the heater and place the
heater gently on its head to mount the feet.
3. Two screws must be fastened on each foot bracket.
4. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.
1. Remove the pre-mounted screws on both legs before you insert them into the
brackets, so that you get a stable foot.
2. Attach the legs to the brackets by tightening 2 screws into each bracket.
3. Remove the pre-mounted screws from the bottom of the heater and place the
heater gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket.
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.
Mechanical thermostat
Mechanical thermostat
Electronic thermostat
Electronic thermostat
A
A
B
B
•
4 screws (pre-mounted)
•
2 foot brackets
•
2 rails for the feet
•
8 screws (pre-mounted)
•
2 foot brackets
•
2 rails for the feet
Instructions mechanical thermostat
Control Panel
2. Thermostat: Adjust the desired heat setting
3. Output selector:
1. Indicator
0: OFF
I: 750W
II: 1250W
III: 2000W
WARNING!
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
INSTRUCTIONS BEFORE USING THE HEATER!
ATTENTION!
This heater is only meant to be used as a supplementary heating
source, and must not be used without supervision
Please see table on page 4 for which models that have mechanical/electronic thermostats
Please see table on page 4 for which models that have mechanical/electronic thermostats
Please see table on page 4 for which models that have mechanical thermostats
willheat.cn
