Wilfa Cool 12, Operating Instructions Manual

Page: 11 / 29

11
English
English
• When unit is off, press this button to set Timer On. T-ON and H icon will be blinking.
Within 5s, press + or - button to adjust the time for Timer On. Pr or - button
once will increase or decrease the time by 0.5h. H or - button for 2s, time
will change quickly. Release the button after your required set time is reached.
Then press TIMER button to confirm it. T-ON and H icon will stop blinking.
• Cancel Timer On/Off: If Timer function is set up, press TIMER button once to review
the remaining time. Within 5s, press TIMER button again to cancel this function.
Note:
• Timer setting range: 0.5~24h
• The interval between two motions can’t exceed 5s, otherwise the remote controller will exit
setting status.
FUNCTION INTRODUCTION FOR COMBINATION BUTTONS
Child lock function
Pressing “+” and “-” buttons simultaneously will turn "ON" or turn "OFF" child lock
function. When child lock function is started up, LOCK indicator on remote controller
is ON. If you operate the remote controller, remote controller won’t send signal.
Temperature display switchover function
Under OFF status, pressing “-” button and “MODE” button simultaneously can
switch between °C and °F.
OPERATION GUIDE
1. After putting through the power, press ”ON/OFF” button on remote controller
to turn on the air conditioner.
2. Press ”MODE” button to select your required mode: COOL, DRY, FAN.
3. Press ”+” or ”-” button to set your required temperature.
4. Press ”FAN” button to set your required fan speed: auto, low, medium and high
speed.
REPLACEMENT OF BATTERIES IN REMOTE CONTROLLER
1. Press the back side of remote controller on the spot
marked with ” ”, and then push out the cover of
battery box along the arrow direction.
2. Replace two (AAA 1.5V) dry batteries and make sure
the positions of + and - polar are correct.
3. Reinstall the cover of battery box.
battery
reinstall
remove
cover of battery box