Wilbur Curtis Company Gemini GEM-612ILD Instructions Manual Download Page 6

Page: 6 / 7

CLEANING

REGULAR AND PREVENTIVE MAINTENANCE IS ESSENTIAL IN KEEPING YOUR ADS SYSTEM LOOKING AND
WORKING LIKE NEW.

- PREVENTIVE MAINTENANCE

1. Remove spray head from the brewer and clean it weekly or more often in heavy lime areas.

2. Remove and Clean the Satellite faucet seat cups weekly. Replace if cracked or leaking.

3. Remove hot water spout aerator; clean it once a week.

4. Periodic De-Liming of Heat Tank may be necessary especially in areas with especially hard water.
(Excessive Lime buildup in heat tank may void warranty.)

- CLEANING

A daily routine of cleaning should maintain its new appearance and insure the good flavor of the coffee.

1. Wipe off any spills, dust or debris from the exterior surfaces.

2. Clean the outside of the brewer and satellite with stainless steel polish. Coarser agents may scratch the

machine.

3. Clean and polish inside the Satellite with a SOFT scouring pad.

4. Slide out brew cone. Rinse thoroughly with clean water.

5. Remove the spray head and clean. Clean around the dome area, wiping with a nontoxic cleaner.

6. Clean the brew cone rails with a damp cloth or brush. Dry thoroughly with clean cloth.

IMPORTANT: Error Codes
are indicated by the red
Ready to Brew light. If an
Error Code occurs the

unit will shut down all functions
including heating, water inlet,
water delivery. ALWAYS confirm
Error Code THREE times.

ERROR CODES

Curtis ADS Digital Systems contain various safety features in the electronic circuitry that will shut down the
functions of the unit in the event of system failures. Error codes are signalled by the red READY-TO-BREW
light blinking.

INTERPRETING

INTERPRETING THE CODES

THE CODES

Error Codes can only be reset by turning the rear toggle switch to Standby for a minimum of 10
seconds, then returning the switch to ON. Any service required for your Curtis system must be
performed by a qualified service technician.

ADS technology features a state-of-the-art Error Code System. This is designed to quickly advise you of any
problems the system may experience expediting service or repair. Occasionally an error reported may be a
problem with the water supply or electrical power, NOT directly associated with a fault of the Curtis System
itself. An example of this includes:

Clogged Water Filter

Clogged Water Filter – Indicated by a Water Level Error Code

Error Codes are indicated by

blinking a pattern as follows:

= Long Flash = Short Flash

- WATER LEVEL PROBLEM
- TEMPERATURE SENSOR PROBLEM

ADS ERROR CODES

CAUTION: Do not use
cleansers, bleach,
powders or any other

substance that contains chlorine.
These products promote
corrosion and will pit the stainless
steel. USE OF THESE PRODUCTS
WILL VOID THE WARRANTY.