wiking Luma 1, Installation And User Manual

Page: 12 / 24

Page 12 of 24 pages
be CE marked. Furthermore, it must have obtained the classification of G in soot fire testing.
The required distance to combustible material must be complied with in accordance with the
brand label. Ask your WIKING retailer for further information.
Changing the Smoke Outlet from Top Outlet to Back Outlet
(WIKING Luma 1 - Luma 4)
Proceed as follows to change the smoke outlet from top outlet to back outlet:
1. Lift the top plate off the stove.
2. Lift the rear plate off the stove.
3. Remove the smoke ring on the top of the stove by unscrewing the three screws and lifting it off.
4. There is a cut-out for the flue duct in the back plate. Break off the plate within this cut-out to
make a hole that the flue duct can fit into.
5. Remove the cover plate on the back of the stove by unscrewing the three screws (Torx Bit
no. 30) and lifting it off.
6. Install the cover plate on top of the stove with the three screws.
7. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with the
three screws.
8. Place the rear plate on the stove again.
9. Replace the top plate on stove.
A top cover can be bought as an accessory to cover the hole in the top plate of the stove
if the stove is connected to a back smoke outlet.
Changing the Smoke Outlet from Top Outlet to Back Outlet
(WIKING Luma 5 - Luma 6) (drawing F)
Proceed as follows to change the smoke outlet from top outlet to back outlet:
1. Lift the top plate off the stove.
2. Lift the rear plate off the stove.
3. Lift the front (1) of the heat storage compartment up and forward, unhooking it from the
four guide pins (2).
4. Loosen and remove the three screws in the flue ring (3) in the bottom of the heat storage
compartment. Remove the smoke ring.
5. There is a cut-out for the flue duct in the back plate. Break off the plate (4) within this
cut-out to make a hole that the flue duct can fit into. It is recommended that you use a
wire- cutter.
6. Remove the cover plate at the rear of the stove by loosening and removing the three
screws (Torx Bit no. 30) and lifting it off.
7. Mount the cover plate over the smoke outlet in the bottom of the heat storage compart
ment, using the three screws.
8. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with
the three screws.
9. Hook the front (1) on to the four guide pins (2).
10. Place the rear plate on the stove again.
11. Place the top plate on the stove again.
A top cover can be bought as an accessory to cover the hole in the top plate of the stove if the
stove is connected to a back smoke outlet.