WIKA PSD-4-ECO, Operating Instructions Manual

Page: 16 / 140

14247391.01 07/2019 EN/DE/FR/ES
16 WIKA operating instructions, model PSD-4-ECO
EN
5. Commissioning, operation
Menu
item
Description Parameter Factory setting
DR1/DR2 Reset delay time, at which the reset value
must be continuously present until an
electrical signal change occurs (RP1 or
RP2)
0.00 ... 65.00 s 0.00 s
OU1 / OU2 Switching function (switching output 1 / 2) HNO = hysteresis function, normally open HNO
HNC = hysteresis function, normally closed
FNO = window function, normally open
FNC = window function, normally closed
AVGD Damping (digital display) 0.00 ... 65.00 s 0.20 s
AVG1/AVG2 Damping (switching output 1 / 2) 0.00 ... 65.00 s 0.00 s
AVG3 Damping (analogue signal) 0.00 ... 65.00 s 0.00 s
UNIT Unit switching BAR, mBAR, MPA, KPA, PSI, KGcm (kg/cm²), % Order-related
0SET Zero point setting / Executing “Autozero”
(max. 3 % of span)
Yes / No
DISM Display value in display mode ACT = current system pressure ACT
LOW, HIGH = min/max system pressure
OFF = display off
SP1/FH1 = set switching value
RP1/FL1 = set reset value
SP2/FH2 = set switching value
RP2/FL2 = set reset value
DISU Refresh rate (digital display) 1, 2, 5, 10 updates/second 5
DISR Rotate the indication by 180° (digital
display)
Yes / No
DRES Resolution (digital display) OPT = optimised (Stabilises the display of the
measured values, with rounding factors for the last
digit, optimised for the measuring range)
FULL = maximum (finest resolution, if required, for a
stable display of measured values a damping must
be set for the digital display)
OPT