WIKA CPC8000-H, Operating Instructions Manual

Page: 43 / 85

7. Operation
WIKA Operating Instruction High Pressure Controller, Model CPC8000-H 43
GB
1
42
3
59
9
3
.0
0/
0
6/2
0
17
/GB
Load (Configuration)
Each configuration can store a complete set of parameters and settings. Configurations can be
recalled (loaded) as needed. Configurations contain settings for the following set of parameters:
Table 3 Stored parameters
Lower limit Rate stable delay
Upper limit Vent rate
Setpoint Emulation mode (gauge/abs)
Step Filter
Rate setpoint Resolution
Rate step Units
Stable window Rate units
Stable delay Secondary units
Rate stable window Brightness
Volume
Explanation on how to set up each configuration can be found below in Section 7.3.1.5. When the
[Load] button is chosen a choice of several configurations are displayed on the sidebar. When one
configuration is chosen its loads parameters and settings will be active in the instrument.
Figure 7-28 Load (configuration)
Save (configuration)
The [Save] button within the [General] tab of the Setup [ ] menu, shown in
“
Figure 7-29 Save
(configuration)
”
, provides a place to save configurations for the instrument. When the [Save] button is
chosen a list of configuration numbers are displayed on the sidebar. When a configuration number is
chosen and the check mark [ ] is pressed the current instrument settings will be saved within this
configuration number. Instrument settings that are saved in configuration settings are given in section
7.3.1.5 Load (Configuration).
Figure 7-29 Save (configuration)