WIKA A-RB-1, Operating Instructions Manual

Page: 14 / 40

14
2.6.2 Setting of alarm 2
(see also appendix B)
Programming of the alarm 2 contact is initiated by hitting key SET 2,
otherwise fully identically to the programming of no. 1.
2.6.3 Verification of set points of alarm 1
(see also appendix B)
Short hitting of the SET 1 key initiates "SP1" to appear at the display,
followed by the current settings of (SE) and (SA) of alarm contact no. 1
Indication can be terminated at any time by hitting the RESET key. (see
also 2.7)
2.6.4 Verification of set points of alarm 2
(see also appendix B)
Verification of the alarm 2 contact is initiated by hitting key SET 2,
otherwise fully identical to the verification of no. 1.
2.7 RESET key 'G'
The RESET key enables to - erase memories - exit programming mode -
exit verification mode.
2.7.1 Erase data memory
Hitting the RESET key while the instrument is operative erases the data
memories as explained below:
- When pressed in REAL mode (indication of value measured), the
MIN and MAX memories will be erased.
- When pressed in HOLD mode, this will reset the instrument into
REAL mode.
- When pressed in MIN mode, only the MIN memory will be erased.
- When pressed in MAX mode, only the MAX memory will be erased.