.
3- IMPORTANT INSTALLATION INSTRUCTIONS
WARNING – To reduce the risk of fire or injury read and follow all instructions.
-Do not install or operate the system in an enclosed space. Do not block discharge grill. Keep all objects
at least 6” away from the casing. NEVER place the system up against a wall.
-Do not kink hose or restrict airflow in any way.
SAVE THE INSTRUCTION FOR FUTURE REFERENCE
4- IMPORTANT OPERATIONS INSTRUCTIONS
WARNING – To reduce the risk of damage to your system read and follow all
instructions. Failure to follow these guidelines may result in undesired operation or
damage that will not be covered under warranty.
-THE SYSTEM IS DESIGNED TO BE CONSTANTLY POWERED (PLUGGED IN). USE THE ON/OFF
ONLY SWITCH TO TURN THE SYSTEM ON & OFF
-
ALWAYS SWITCH THE POWER OFF BEFORE UNPLUGGING THE SYSTEM FROM THE MAIN
POWER SOURCE OR BEFORE CUTTING POWER TO THE RECEPTACLE. FAILURE TO DO SO
MAY CAUSE DAMAGE TO THE SYSTEM THAT IS NOT COVERED UNDER WARRANTY.
-
QUATRO IS NOT LIABLE FOR MISAPPLIED EQUIPMENT. ALWAYS CHECK SYSTEM VOLTAGE
BEFORE PLUGGING INTO POWER SOURCE
Warning:
This is a class A product. In domestic environment, this product may cause radio interference in which case the user
may be required to take adequate measures.
5- PRE START-UP CHECKLIST
a) Place
the
IVac System
in the desired area for use.
b) Open bottom access door. Slide out drawer and remove all accessories & manual. Slide drawer back in and
close bottom access door.
c) Open top access door & verify that all the filters are installed properly. Close access door and screw in knob.
d) Connect the supplied hose to Wieland Zenotec Milling Machine
6- START-UP
a) Insert male end of power cord into grounded circuit of the proper voltage and that can handle the system
amperage.
b) Plug in the supplied remote cable to the iVac & the Wieland Zenotec Milling Machine.
c) Start a process on the Zenotech Milling Machine. The iVac will start up by itself when it receives the 24VDC
control signal from the Zenotec milling machine system
d) Adjust fan speed controls to the minimum required airflow. As the filters get dirty the system will automatically
increase speed to keep a constant airflow.
WARNING: DO NOT OPERATE UNIT UNLESS ALL FILTERS ARE IN PLACE.
