Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
21.10.14 Working
instructions
WIDOS RS 315
Page 20 of 38
4.6. Circular cutting device (optional)
On the circular cutting device, it is possible to cut pipes from OD 50 mm up to OD 200 mm,
with radii from 50 mm up to 240 mm that are needed for the branch welding of main pipes at
90° / 60° / 45°.
4.6.1. Clamping belt for circular cutting
.
Put the clamping belt around the pipe and through the slots of the prism.
In order to tension, pull the belt at its loose end in a way that it surrounds the pipe slightly;
afterwards move the belt lock in arrow direction.
Move the ratchet handle repeatedly in arrow direction thus tightening the pipe. The ratchet
snaps into place at both ends.
By pulling the retaining clip into direction of the ratchet handle, you may release the belt again.
Support with swivelling prism
Swivel plate
Saw blade
Center of rotation
Hand lever to move the swivel plate
Retaining clip
Ratchet handle
