Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
21.10.14 Working
instructions
WIDOS RS 315
Page 18 of 38
Please take the exact setting and further details from the separately enclosed working
instructions of the laser, type: ZA3.
The saw blade covering is recommended to be adjusted in a way that the lower edge of the
cover is a bit above the pipe to be cut.
In order to displace the covering, detach the star screw and push the saw blade covering
to the desired height. Afterwards, tighten the star screw again.
4.5. Clamping
pipe
4.5.1. Pipe clamping device (optional)
How to set the clamping device:
Release clamping lever 2 of the telescopic clamping arm and push the telescope in / out
(arrow) of the clamping arm; arrest the desired position with clamping lever 2.
In order to swing the clamping arm, release clamping lever 1, swing the clamping arm into
the desired position and lock it with clamping lever 1.
The pipe clamper is turning horizontally.
Upon clamping it is turned manually onto the pipe center.
The height of the clamping arm can be adjusted by means of the control slide. For that
purpose release the screw in the control slide, bring the clamping arm to the desired height
and tighten the screw again.
By turning the lever of the manual valve, the pipe clamping fixture is moved up and
downwards and the pipe is clamped.
Regulate the speed of opening and closing the pipe clamping fixture at the respective exit
air - one-way flow restrictor.
Set the desired clamping pressure at the pressure regulator.
Clamping arm pullout
Clamping lever 2 for the displacement of the clamping
arm pullout
Clamping lever 1 to swing the clamping arm
Pipe clamping fixture with handle for the guiding
Adjusting ring
Pipe support
Control slide with hand lever for the clamping
Pressure regulator
Exit air restrictor for the opening
Exit air restrictor for the closure
