Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen
Fax
+49 (0) 71 52 99 39 - 40
Website: http://www.widos.de
Email: [email protected]
13.10.2014
Working instructions WIDOS PSM 10 XHS
Page 22 of 29
7. Maintenance / storage / transport
7.1. General
•
Damaged parts have to be immediately replaced, in particular be careful with electric parts,
dirt and humidity are very good conductors.
•
In case of repair do only use original WIDOS – spare parts.
•
Control resp. refasten all screwed connections if loose every 3 months.
All maintenance and repair work must be executed with the machine being
switched off.
Thereby, the machine has to be protected against unintentional activation.
Prescribed maintenance and repair works are to be executed in due time. DVS
recommends repair works after one year.
Machines which are loaded above the average, the checking cycle should be
shortened. The works have to be executed by company WIDOS GmbH or by one of
its authorized representatives.
The linear guides must be cleaned every week, e.g. with a brush.
Check the linear guide carriages every 3 months and grease them over the
lubricating nipple if necessary.
Dirty guides may cramp and run heavily.
7.2. Clamping elements
In order to warrant a long lifetime, threaded spindles and joint pieces for clamping the sheets
should be regularly cleaned and greased.
7.3. Cleaning of the machine
The materials you use for cleaning the machine have to be properly treated and have to be
appropriately disposed of, especially:
•
when cleaning with solvents
•
when greasing with oil and grease.
7.4. Transport
•
The machine has to be handled carefully.
•
Protect against shocks and hits.
7.5. Disposal
The machine and wear parts have to be disposed of at the end of their useful life
according to the common Waste Management Laws in a proper and
environmentally sound manner.
