Kunststoffschweißtechnik
Starting and operating
Chapter 5
22.11.2005
Working Instructions WIDOS 4900 CNC 3.0 (110 V)
Page 26 of 76
5.7.2. PCMCIA
The unit CNC 3.0 has a drive for a PCMCIA card.
The machine stores the welding data in the internal memory as well as on the PCMCIA card if
a card is in the drive.
PCMCIA cards of the type SRAM can be used in the drive.
On a card with 256 kB memory capacity, the welding data of about 1200 weldings can have
place.
•
The PCMCIA card must be formatted before usage.
•
Insert the card with the arrow to the top and in direction of the arrow (socket side)
carefully
and with a low pressure into the reading unit.
•
The card can be read out with a WICON program.
•
The card may not be bent, opened, overheated and become wet!
•
For changing the battery necessarily consult the working instructions of the card.
Put empty batteries in the special refuse!
5.7.3. Barcode
•
For reading the barcode, glide smoothly over the barcode with the barcode reader
(maintained vertically).
•
The reader is ready as soon as the red light at its end is on.
5.8. Switching the CNC 3.0 on
As soon as the control unit
CNC 3.0
is connected to the mains and switched on at the main
switch, the display is lightened (the computer is being initialised).
Display:
2
nd
line:
WIDOS GmbH
Germany
after a few seconds, the display changes
Display:
2
nd
line:
version: 0.00.00
serial no: 0000000
Number of the software version
Serial number of the machine
after a few seconds, the display changes
Display:
2
nd
line:
000 free weldings
0000 PCMCIA
Number of free memory capacity (RAM)
Number of free memory capacity PCMCIA
after a few seconds, the display changes
