Wido WD030120150, Manual

Page: 9 / 20

150W/350W BENCH GRINDER ENG
OPERATING INSTRUCTIONS
Note:
Before using the power tool, read the instruction manual carefully.
1. Intended use
The machine is intended for sharpening tools such as drill bits and chisels or grinding small metal parts.
It is not suitable for grinding heavy sheet metal parts. It is not suitable for grinding soft substance such
as wood, plastic, lead, magnesium and light alloys.
2. Before using your power tool
1) The power tool must be mounted on a level and stable surface (e. g., workbench) prior to using.
2) Check the grinding wheels. The grinding wheels must be properly mounted and must rotate freely.
Carry out a one minute test run with no load.
3) Do not use cracked or damaged grinding wheels.
3. Fitting and adjusting the eye shields and spark deflectors
Warning:
Prior to fitting the eye shields and spark deflectors, ensure the grinder is turned off and the
power plug is removed from the socket.
Note:
Always check to ensure the eye shields and spark deflectors are correctly fitted and they are
correctly adjusted each time the grinder is used. Eye shields and spark deflectors must be fitted over
each grinding wheel.
1) Position the eye shield and spark deflector to the top of the wheel guard.
2) Reinserting the bolt through the spark deflector and wheel guard, followed by the washer, spring
washer, and nut.
3) Slide the spark deflector up or down so that the bottom edge is less than 5mm from the surface of
the wheel, but not touching the wheel.
4) Tighten to secure the spark deflector onto the wheel guard.
5) Rotate the wheel one full revolution by hand to ensure the wheel can rotate without contacting the
spark deflector bracket. Firmly tighten the bolt retaining the bracket (See Fig 1).
6) Repeat the assembly operation for the second eye shield and spark deflector.
4. Fitting and adjusting the tool rests
Warning:
• Prior to fitting the tool rests, ensure the grinder is turned off and the power plug is removed from the
socket.
• To reduce the risk of injury, never use a grinder on which the tool rest has not been fitted or where the
tool rest has not been correctly adjusted.
1) Hold the tool rest in the correct position against the inner surface of the wheel guard.
2) Insert bolt through wheel guard and tool rest, followed by a washer, spring washer, and locking knob.
3) Tighten the locking knob sufficiently to support the tool rest but still allowing the tool rest to slide
inwards and outwards.
4) Slide the tool rest to within a maximum of 1.5mm from the wheel. Rotate the wheel one full revolution
by hand to ensure the wheel does not contact the tool rest. Firmly tighten the locking knob firmly to
retain the assembly (See Fig 2).
5) Repeat the assembly operation for the second tool rest.
9