8
OPERATING YOUR FIRE—REMOTE OPTION FIRE
REMOTE OPERATION:
(Not applicable to LE Timer fires or if the remote option has not been purchased)
On first use insert the batteries into the remote control handset—see battery
replacement section below. With the mains supply connected to the fire and
switched on the fire can be operated.
CARE
DO NOT drop - DO NOT immerse in liquids - DO NOT leave flat batteries in
the unit -Clean only with a dry cloth.
As this product operates using infra-red, ensure there is a clear line of sight
between the handset and the appliance for it to operate effectively.
REMOTE HANDSET BATTERY REPLACEMENT:
To replace the batteries in the remote handset remove the battery compartment cover and remove
the batteries. Replace the batteries with either rechargeable or non-rechargeable batteries of type:
AAA, MN2400, LR23, or UM4.
DO NOT MIX
Rechargeable and Non rechargeable batteries.
To operate your fire in Remote mode follow the steps below:
1) When the Mains supply has been turned on the Fire can be activated to
Standby mode by pressing
the switch on the Fire as shown.
2) To switch the Fire on press on the remote handset; Now the Flame
effect and Fuel bed will be on.
3) Press ‘Flame intensity -‘; Flame effect and Fuel bed become dimmer
(there are 4 steps).
4) Press ’Flame int’; Flame effect and Fuel bed become brighter
(there are 4 steps).
5) Press ‘DISPLAY ON/OFF’ Control, the Flame effect and Fuel bed switch
on/off.
6) Press ’HEATER ON/OFF’; The Heater will come on if the set tempera-
ture is greater than the temperature of the environment.
7) Press ‘Temp +’; the set temperature will raise 1ºC per press (after 28 the
Fire will be permanently on, a further press will reset to the minimum
temperature).
8) Press ‘Temp -’; the set temperature will lower 1ºC per press.
9) Press ’HEATER ON/
OFF’ again; the Heater will switch off.
10) At any stage if you press the Fire will go off.
11) The Fire can be operated with Flame effect and Fuel bed with or without
the Heater on.
+ -
-
+
+ -
-
+
PRESS
DISPLAY
ON/OFF
FLAME
INTENSITY
HEATER
ON/OFF
-
+
-
+
TEMP
