www.whytetechnologies.com
www.whytetechnologies.com
8
9
Multiswitches. The Auxiliary DC Output port is active whether the Multiswitch
is being Line Powered or powered directly.
A 12V DC switch is available to power a Mast Head Amplifier connected to
the TERR input. If a Mast Amplifier is not being used this
must
be left in the off
position.
Care must be taken to select the appropriate type and number of PSU's required
depending on the current requirements of the system as a whole.
INSTALLATION INSTRUCTIONS
MOUNTING THE MULTISWITCH
Select a suitable location to install the Multiswitch. Do not install the Multiswitch
in damp, humid, hot or dusty areas. Using the screw slots on the Corner Brackets,
secure the Multiswitch using the appropriate fixing screws and wall plugs to suit
the relevant wall surface or cabinet.
CONNECTING THE SAT & TERR INPUT CABLES
Use a suitably sized Satellite Dish to provide adequate signal levels from the
satellite being received. Ensure that the Satellite Drop Cables are connected
correctly in the corresponding order with respect to the LNB and the Multiswitch
SAT inputs (Quattro LNB only). Ensure that the F Connectors are properly sealed
against water ingress.
If a Composite Cable (multi core coaxial cable) has been used, ensure that the
outer jacket is not facing upwards and cannot collect rain water. Check the
Terrestrial Drop Cable and ensure that this has also been sealed against water
ingress. If a Triplexer has been used to combine FM and DAB aerials with the
UHF Terrestrial Aerial, ensure that this is also water tight. Ensure that all drop
cables have drip loops prior to their entering the building.
Connect the SAT and TERR drop cables to the corresponding Satellite & TERR
Inputs of the Multiswitch.
Whyte
