Whynter WC-201TD, User Manual

Page: 11 / 12

Page 11
Troubleshooting Guide
Most common problems can be resolved by referring to the troubleshooting suggestions listed below.
PROBLEM POSSIBLE CAUSE SOLUTIONS
The Wine Cooler does
not turn on.
 There is a power failure.
 The Wine Cooler is not plugged in.
 A house fuse has blown or the circuit
breaker is tripped.
 Ensure the Wine Cooler is plugged
in and the power outlet has power.
 Replace the broken fuse or reset the
breaker.
The Wine Cooler is not
cold enough.
 The set temperature too high.
 The Wine Cooler is placed too close to a
heat source.
 The door is opened too often.
 The door is not closed completely.
 The door gasket does not seal properly.
 The front bottom grille does not have
sufficient ventilation.
 Adjust the set temperature
 Keep the Wine Cooler away from
sunshine or other heat sources.
 Close the door tightly and do not
open the door too frequently or for a
long period of time.
 Ensure the door gasket is not loose.
The front bottom grille must be
completely unobstructed.
The Wine Cooler is
cooling too much
 The Wine Cooler ventilation is not properly
set
 There is an obstruction of air flow
 Make sure to follow the
recommended clearances for
ventilation
 Make sure that no object is blocking
the air flow
The Wine Cooler turns
on and off frequently.
 The ambient (room) temperature is too low
or high.
 A large amount of contents has been
added to the Wine Cooler.
 The door is opened too often.
 The door is not closed completely.
 The door gasket does not seal properly.
 Decrease or increase the ambient
(room) temperature.
 To minimize internal temperature
fluctuation, do not add large amount
of contents at once.
 Close the door tightly and do not
open the door too frequently or for a
long period of time.
 Ensure the door gasket is not loose.
Frost forming in the Wine
Cooler.
 The environment is too humid.
 The ambient temperature is too low.
 The door is opened too frequently or for a
long period of time.
 Although this unit uses an auto-
defrost system, under certain
conditions, manual defrosting may
be required. If frost builds up, try
running the cooler on a warmer
temperature setting.
 Close the door tightly and do not
open the door too frequently or for a
long period of time.
 Unplug the unit to allow the frost to
melt.
The Wine Cooler makes
too much noise.
 The Wine Cooler is not level.  Make sure the unit is on a hard and
level surface. Do not place the Wine
Cooler on carpet.
The door does not close
properly.
 The Wine Cooler is not level.
 The door was reversed and not properly
installed.
 The shelves are out of position.
 Make sure the cooler is on a hard
and level surface. Avoid placing the
Wine Cooler on a carpeted or soft
surface.
 Correctly install the shelves.